Etc Echo Light Sensor Manual de usuario descargar pdf (Pagina 5)

ETC Installation Guide

Echo™ Light Sensor

Page 5 of 12 Echo Light Sensor Installation Guide

Step 4: Orient the smooth side of the mounting plate to the junction box. Pull

the following wires from the junction box through the provided holes of

the mounting plate:

• EchoConnect bus wires or EchoConnect pigtail and ESD ground wires

depending on the installation.

• Remote Light Sensor Head wires (if remotely mounting Light Sensor

Heads).

Step 5: Secure the mounting plate to the junction box using the screws

provided (both short and long screws are included for convenience).

Step 6: Strip each wire 5/16” (8mm) and terminate the EchoConnect (white

and black wires) and ground wire (green/yellow) to the EchoConnect

terminal block located on the sensor controller. Torque each

termination to 3.1-3.5 in-lb.

a: Terminate the white incoming wire to the data + terminal.

b: Terminate the black incoming wire to the data - terminal.

c: Terminate the green/yellow (ground) wire to the labeled ground

terminal.

Step 7: To terminate remote Light Sensor Heads, See “Terminating Remote

Light Sensor Head Control Wiring” on page 8.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Etc Echo Light Sensor Manual de usuario Pagina 5