Etc Sensor+ CE Rack (ESR+) CEM+ to CEM3 Retrofit Manual de usuario

Sensor+ Rack (ESR+ Series) CEM+ to CEM3 Retrofit ManualRevision ACopyright © 2011 Electronic Theatre Controls, Inc.All Rights reserved.Product informa

8 CEM3 Sensor+ ESR+ Rack Retrofit ManualAttach New Power HarnessStep 1: Connect the old power connector to the new power harness adapter found in the

2 The Retrofit 9wires to the new location.• Carefully pull excess slack in the beacon wires down from the top of the rack.• Cut one or two of the bott

10 CEM3 Sensor+ ESR+ Rack Retrofit Manual.Step 5: (IEC Only) connect the brown and blue wires to the rear of the IEC connector in the NEFM slot. Conne

2 The Retrofit 11Step 9: With the tabs fully inserted in the sides of the rack, pull the backplane towards the front of the rack to line up the screw

12 CEM3 Sensor+ ESR+ Rack Retrofit Manual“On” position = switch pushed to the topd: Check to see that the “Emergency Contact” switch is set to the app

2 The Retrofit 13Change out the Beacon PCBStep 1: Remove the top four dimmer modules from the rack to allow access to the PCB.Step 2: Remove the two s

14 CEM3 Sensor+ ESR+ Rack Retrofit Manualsource is not present.Configure the CEM3Step 1: Configure the rack to reflect the dimmer module types install

2 The Retrofit 15

16 CEM3 Sensor+ ESR+ Rack Retrofit Manual

ETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC®, and Sensor® are

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

Introduction 1IntroductionThis manual is intended to guide ETC Service Technicians through the process of upgrading existing Sensor+ rack installation

2 CEM3 Sensor+ ESR+ Rack Retrofit ManualSafetyPlease note the following safety warnings before use:• Disconnect power from the racks before all mainte

1 Unpack and Organise 3Section 1Unpack and OrganiseThe table below lists the parts and components needed to retrofit a Sensor+ rack (ESR+12, 24, 36, o

4 CEM3 Sensor+ ESR+ Rack Retrofit Manual

2 The Retrofit 5Section 2The RetrofitPreparationStep 1: Use the Sensor+ Connect web interface to download and save the current configuration out of th

6 CEM3 Sensor+ ESR+ Rack Retrofit ManualStep 3: Unscrew the backplane metal from the rack. There is one screw in each upper-corner on single height ba

2 The Retrofit 7IEC Component Transfer(IEC ONLY) You must transfer the components from the NEFM slot to the new backplane. a: Using a small blade scre