Etc Sensor+ Touring Rack CEM+ to CEM3 Retrofit Manual de usuario

Sensor Touring Rack (SP Series) CEM to CEM3 Retrofit ManualRevision BCopyright © Electronic Theatre Controls, Inc.All Rights reserved.Product informat

8 CEM3 Sensor Touring Rack Retrofit ManualStep 6: Connect the data cables to the new control input panel. The new multi-colored ribbon cable and ether

2 The Retrofit 9the panel a bit loose for the next step.Step 9: Reinstall the tour guides (under the screw heads still in the rack) and fully tighten

10 CEM3 Sensor Touring Rack Retrofit ManualPower TerminationStep 1: Follow the path of the existing J1 power wiring and clip the first wire-tie holdin

2 The Retrofit 11Data Cabling PreparationStep 1: Identify the different dimmer output ribbon cable transition cards. An SP48 will only use a single up

12 CEM3 Sensor Touring Rack Retrofit ManualBackplane SettingsUpgrade kit backplanes ship from the factory with all DIP switches in the off (down) posi

2 The Retrofit 13Spider Board Retrofit (only SP96 Large or “Double Small”)Sensor 96 dimmer touring racks have a “Spider board” installed, which assist

14 CEM3 Sensor Touring Rack Retrofit ManualMake Connections and Install the New BackplaneStep 1: Install the dimmer output ribbon cables/transition ca

2 The Retrofit 15Step 11: Dress the control data ribbon cable, the beacon cable and the Ethernet cable through the cable clips neatly across the top o

16 CEM3 Sensor Touring Rack Retrofit ManualUpgrading the Rack DoorDepending on the kit you ordered, you may be replacing the rack door or you may only

2 The Retrofit 17Finish UpStep 1: Remove the CEM baffle from the spare CEM slot (if available). It is held by two screws, one in each upper side corne

ETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC®, and Sensor® are

18 CEM3 Sensor Touring Rack Retrofit Manual

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

Introduction 1IntroductionThis manual is intended to guide ETC Service Technicians through the process of upgrading existing Sensor® touring racks to

2 CEM3 Sensor Touring Rack Retrofit ManualSafetyPlease note the following safety warnings before use:• Disconnect power from the racks before all main

1 Unpack and Organize 3Section 1Unpack and OrganizeThe table below lists the parts and components needed to retrofit a Sensor touring rack (SP48, 96,

4 CEM3 Sensor Touring Rack Retrofit Manual* Need/quantity based on specific rack or door type. See Sensor3 Touring Rack Retrofit Kit order sheet for d

2 The Retrofit 5Section 2The RetrofitRack GeographyThroughout this manual directions are given which refer to the front, back, left, and right sides o

6 CEM3 Sensor Touring Rack Retrofit ManualRemove the OldStep 1: Unscrew the dimmer output edge connectors from the backplane metal.Step 2: Carefully f

2 The Retrofit 7Control Input Panel ReplacementStep 1: From the open left side of the rack, remove the control data ribbon cable from the retainer cli