Etc SmartFade v3.0.1 Manual de usuario descargar pdf (Pagina 63)

5 Playback 57

Memories

Memories are played back from the faders in MEMS mode. In each of the 12 fader pages

the buttons with memories stored will light up dimmed in red when a page is selected. When

the fader is contributing to the output, the button will light up in full.

Select Fader Page

If a fader is above zero when a different page is selected, it will not be updated to the

content of the new page until it is brought to zero. Press MEMS twice within 1 second to

select page 1 quickly.

Memory Bump Modes

The content of memory faders can be bumped to the level of the BUMPS fader in two ways.

This is controlled with the SOLO button.

• OFF = The level generated by pressing a bump button adds into the live output.

• ON = The level generated by pressing a bump button replaces the current output.

Clear Output from Memory Faders

Action Console Feedback

Select fader page (Held) As long as the button is held, the current fader

page is indicated with a lit bump 1-12. Bumps

for pages with recorded information will blink.

To select a new page, press bump 1-12 and

let go of the MEMS button.

Action Console Feedback

Clear output from Memory

Faders

and All memory faders will be set to zero.

MEMS

SOLO

CLEAR

MEMS

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 83 84

Sin comentarios

Etc SmartFade v3.0.1 Manual de usuario Pagina 63