Etc Desire Series v1.6.0 User Manual Manual de usuario descargar pdf (Pagina 14)

8 Desire Series v1.6.0 User Manual

Connect (D22 Canopy and Track)

For installation and connection information, refer to Desire Series D22 Installation Guide.

ETC manuals are available for download at http://www.etcconnect.com/downloads.aspx

Focus

Step 1: With power supplied, wait for the fixture to boot up. This will take approximately

ten seconds.

Step 2: Press [] to open the Presets & Sequences menu.

Step 3: Select Focus and then press []. This turns the LED array on to enable

focusing.

Step 4: Adjust the fixture's position as needed.

Step 5: When focusing is complete, press [] to restore the fixture to its original preset.

Step 6: Select [] to return to the home screen.

For information about the user interface, see User Interface Overview, page 40.

Configure

Set DMX Address

Step 1: From the main screen, press [] to open the Main Menu.

Step 2: On the Main Menu, scroll to DMX Start Address and then press [].

Step 3: Use [] or [] to scroll to the desired address.

Step 4: Press [] to select the address number.

Step 5: Press [] to return to the home screen.

A DMX address is not required if using standalone or master/slave control.

Quick Color (Vivid, Lustr+, Fire and Ice, Studio HD)

When there is no DMX signal to the fixture:

Quick Color allows you to easily select a color and its intensity from a predefined menu.

This feature overrides any presets or sequences previously selected and is only available

when there is no external DMX signal to the fixture. For a list of available colors,See

“Presets (Vivid, Lustr+, Fire and Ice, Studio HD)” on page 59.

Note:

Exiting the Quick Color menu will return the fixture to the state it was in prior to

entering the menu.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Sin comentarios

Etc Desire Series v1.6.0 User Manual Manual de usuario Pagina 14