Etc Desire Series v1.6.0 User Manual Manual de usuario descargar pdf (Pagina 11)

Introduction 5

Safety

The Desire series fixtures are intended for professional use only. Read entire User Manual

before using equipment.

WARNING:

Note the following safety warnings before use:

• Do not mount the Desire series fixture on or near a flammable surface.

• Use the D22, D40, and D60 fixtures in dry locations only, where humidity does not

exceed 90 percent (non-condensing). These fixtures are not intended for outdoor use.

(Only the D40XT is approved for outdoor use.)

• Mount and support the fixture only by the primary suspension holes in the yoke or floor

standing yoke.

• Suspend the fixture from a suitable structure using only the hardware rated for the

weight of the fixture.

• In addition to primary suspension, attach a safety cable (ETC Model 400SC or other

approved safety cable or device) to the fixture housing. Appropriate attachment point

(hole) is provided in the protruding tab on the fixture housing.

• Disconnect the unit from power and from DMX before all cleaning and maintenance.

• Maximum recommended ambient operating temperature: Ta=40°C (104°F)

• Maximum anticipated external surface temperature: Tmax=80°C (158°F)

• External temperature after 5 minutes of full-brightness operation and 23°C (74°F)

ambient: 38°C (100°F)

• External Temperature (steady state achieved) at 23°C (74°F): 70°C (158°F)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 99 100

Sin comentarios

Etc Desire Series v1.6.0 User Manual Manual de usuario Pagina 11