Etc Source Four XT HID Zoom Grid Louver Manual de usuario descargar pdf (Pagina 2)

Remove one

screw.

Lens barrel

ear with

screw.

Page 2 of 2

To install the Grid Louver:

Step 1: Remove the screw from the front ring as shown in the illustration. Do not remove the other screws that attach

the ring to the upper rails.

Step 2: Place the Grid Louver over the front ring.

Step 3: Secure the Grid Louver and front ring with the screw.

To install the barrel:

Step 1: Slide the barrel down over the lens rails, aligning the three ridges of the barrel with the ridges on the housing.

Step 2: Tighten the three 4mm hex screws into the ears on the lens barrel.

Partially tighten each screw, working progressively around the barrel until all have been tightened to

25in-lbs (2.82 Nm). DO NOT OVERTIGHTEN.

The nylon washer should be tightly sandwiched between the two flanges at each screw connection.

1 2

Sin comentarios

Etc Source Four XT HID Zoom Grid Louver Manual de usuario Pagina 2