Etc Source Four CE Zoom Manual de usuario

Copyright © 2007 Electronic Theatre Controls, Inc.All Rights reserved.Product information and specifications subject to change.Part Number: 7060M1260-

8 Source Four Zoom CE User ManualEnglishRotating the barrel assemblyStep 1: Loosen the barrel rotation knob directly behind the shutters on the unders

9EnglishSetting the angle within the yokeStep 1: Loosen the yoke locking knobs (see Figure 11). Do not remove them.Step 2: Tilt the luminaire to the d

10 Source Four Zoom CE User ManualEnglishSetting the angle within the moveable yokeStep 1: Loosen the moveable yoke’s locking knobs. Do not remove the

11EnglishCleaning the ReflectorTo quickly clean the reflector, remove the lens tube and clean the dust from the reflector with a blast of oil-free air

12 Source Four Zoom CE User ManualEnglish

13English

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

i Table of ContentsTable of ContentsETC®, Emphasis®, Expression®, Insight™, Imagine™, Focus™, Express™, Unison®, Obsession® II, ETCNet2™, EDMX™, Sourc

1EnglishDeclaration of conformityWe, Electronic Theatre Controls, Europe Ltd., declare under sole responsibility that the product:Product name: Source

2 Source Four Zoom CE User ManualEnglishSource Four Zoom CE guidelinesThe Source Four Zoom CE is intended for professional use only. Read the entire U

3EnglishBasic assemblyLuminaire informationWiring and power informationA plug of at least 2.5 amp (220/240V) rating should be attached to the luminair

4 Source Four Zoom CE User ManualEnglishHPL lamp tableColour frame holderThe colour frame holder is equipped with a spring-loaded retaining clip that

5EnglishReplacing the HPL lampA lamp must be installed before you use the luminaire.Step 1: Disconnect power to the Source Four Zoom CE before install

6 Source Four Zoom CE User ManualEnglishCentering lamp and adjusting the fieldThe two concentric knobs located on the lamp housing allow you to align

7EnglishShaping the beamThe beam can be shaped using the shutters (see Figure 8), a pattern, an optional drop-in iris, or by rotating the barrel.Patte