Etc LED Configuration Software Programming Guide Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
1 Operation 4
Overview
LED Config runs on a computer that can be connected to the DMX/RDM network via
Gadget or a DMX/RDM gateway. After the fixtures are configured, Gadget or the gateway
can be disconnected and a DMX/RDM lighting control device can be connected to the
network for continued operation.
Figure-1.1 Architecture of using LED Config Tool to configure fixtures on a network.
NOTE:
LED Configuration software should be installed prior to attaching Gadget or a gateway to
the computer to ensure that the Windows driver is installed.
Gadget or a gateway should be connected to the PC before running Configuration
software.
Up to 32 fixtures
Gadget
Console
DMX/RMD network
PC with LED Configuration software
Or
DMX/RDM
gateway
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comentarios a estos manuales

Sin comentarios