Etc Source Four Dimmer Programming Guide Manual de usuario descargar pdf (Pagina 2)

ETC Programming Guide

Source Four Dimmer/ES750/ES1

Source Four Dimmer Programming Guide Page 2 of 3 Electronic Theatre Controls, Inc.

Setting Intensity Level

• Pushing the test button will cause the fixture to enter test mode. This is true even if the current user

interface is showing the DMX channel on the display. The current 0-100% light output level will be

shown on the three digit screen. There is no time-out for test mode.

• Pressing and holding the test button will execute a test fade from 0-100%

• To exit test mode, press and release the test button. When exiting test mode the screen will go

blank, DMX control will be restored and the dimmer will return to the current DMX address.

RDM and User Interface Error Notifications

• Over Current Notification - Output wiring short

• No Load Notification - Lamp has burned out or has been removed

• Over-temp - Fixture has exceeded operating temperatures and will shut down

Switching Output Voltage

The dimmer can be configured to output 230V in place of the default 115V.

To view the current output voltage:

Step 1: Press and hold both the plus and minus buttons. The output voltage will be shown on the

three digit display.

To change the current output voltage:

Step 1: Press and hold both the plus and minus buttons.

Step 2: While holding the plus and minus buttons, hold down the test button. The voltage that you

will be changing to will appear blinking, then a 5-count, count down will be shown.

Once the countdown is complete, the new voltage will be applied and saved.

Note:

If data loss is detected, the lamp output will be held at the last level specified.

Note:

Dimmer will automatically re-enable when fixture is back within operational

temperature range. No user intervention is required to clear the error.

LED Status Indicator

LED Color Description

Solid Green Normal operation

Slow Blinking Green No DMX detected

Fast Blinking Green Invalid or incorrectly wired DMX

Solid Red Error condition exists

WARNING:

Make sure your lamp voltage matches your dimmer voltage. Default dimmer output

regulates to 115V at 100%. A dimmer set to 230V will damage a 115V lamp.

1 2 3

Sin comentarios

Etc Source Four Dimmer Programming Guide Manual de usuario Pagina 2